Studio 10 is a monitor speaker with a monacor SP-310CX PA coaxial speaker and high sensitivity.The speaker was developed by journal Klang+Ton.
The crossover consists of a first order high-pass filter (6 dB per octave slope) for the tweeter and a 3rd order low-pass filter for the woofer.
The frequency response of this speaker is linear. The decay spectrum is nearly perfect. At low volume, i.e. 85 dB at 1 m, the nonlinear distortions are not higher than 0.5% between 300 Hz and 10 000 Hz and doesn't exceed 2% at 95 dB at 1 m.
the crossover components (right),
to be mounted on a small wooden board.
Kit without cabinet, price per speaker EUR 278,00 excl. VAT: € 233.61 / $ 273.33
The high-end kit is delivered with baked varnish air core coils for minimizing microphonic effects. - The current flow through the coil creates a magnetic field which sets the reel of wire in motion. This motion induces a voltage in the coil which adds itself to the signal. The stiffer the reel of wire is, the less the signal will be altered. All capacitors are of type MKP (polypropylen). In series to the tweeter a high quality Clarity-Cap capacitor of type ESA is delivered.
Kit with high-end-crossover without cabinet, price per speaker EUR 303,00 excl. VAT: € 254.62 / $ 297.91
If you want to use a valve amplifier with this speaker an impedance correction should be employed. In this case the component quality is less important; therefore, we offer only one kit (upon request higher quality components are available).
If you prefer to mount the crossover components on a universal PCB instead on wood
PCB 220x155 mm, order no. I-8805002, price per unit: EUR 11,70 excl. VAT: € 9.83 / $ 11.50
We recommend one board per kit (two boards for a speaker pair)